—— STOREAGE AND CLEANING OF PLATES ——
Storage and cleaning of plates
01
Handling and storage
The transportation and storage of the hollow board should be placed horizontally on a solid horizontal pallet with a size not less than the hollow board; during transportation and site processing, the board must be firmly fixed on the pallet; the boards can be stacked and the long board can be placed underneath And the short board is placed on it, there can be no dangling
When using a forklift to move the pallet, a forklift with a length equal to the width of the plate is generally used. The forklift end and the wide pallet may damage the plate and rain
The hollow board is packaged with a white waterproof polyethylene protective film at the factory. This protective film should be removed before the actual installation. The board should be stored in a dry and ventilated place with a roof to avoid direct sunlight and rain.
Even if there is a protective film, avoid leaving the board in the rain for a long time because water will penetrate into the cells; prolonged exposure to sunlight will cause heat to accumulate, and the protective film will soften and melt on the surface of the board, making it difficult to remove
Avoid storing the board without packaging and the port is not sealed. After a few days, dust will accumulate in the hole
Do not place materials with good heat absorption or thermal conductivity together with the plate or on the plate (such as dark materials, metal profiles or steel pipes, steel plates, etc.), they will accumulate and conduct excessive heat and cause damage to the plate. damage
When it is necessary to store the board in the open area, cover it with white opaque polyethylene board, cardboard or other heat-insulating material, and pay attention to cover it completely
02
Maintenance and cleaning
Step 1-small scale
Rinse with warm water: Use neutral soapy water or household detergent and warm water, soft cloth or sponge to remove dirt. Rinse with cold water and dry with a soft cloth to prevent water spots
Rinse the surface with a tap or use a high-pressure water gun. Additives in water should be compatible with the chemistry of the PC sheet
Step 2-wide range
※ Follow the correct steps and use suitable cleaning tools to clean regularly, which can prolong the service life of the product
※ Recommended cleaning solvents: anhydrous alcohol, petroleum ether (BP65°), hexane, canane
※ Precautions
Do not sand or wash the board with high alkali. The cleaners and solvents used for polycarbonate are not necessarily suitable for the boards with anti-UV layer on the surface. To clean the board with anti-UV layer on the surface, do not use butyl cellosolve and isopropanol, and do not use brushes, steel wire balls and other abrasive materials.
No.11 Hengtong Road, Tancheng Economic Development Zone, Linyi City, Shandong Province,China
Tel:0086 15017792129
E-mail:moonybm@outlook.com
Shandong Baike New Material Technology Co., Ltd. 鲁ICP备2020035293号-1 Power by:www.300.cn