As a typical building material, endurance board is often used in the process of house decoration, but often due to unreasonable use by construction personnel, endurance board is wasted, which increases the decoration cost to a certain extent. How to reduce the waste of endurance board? The editor of Shandong Baike endurance board manufacturer tells you. In the process of endurance board processing and construction, some construction workers just make more money, and use it not in accordance with the standard, which causes a huge waste of endurance board materials, which also leads to an increase in material costs. Although the waste of the endurance board at the construction site is inevitable, it is also a degree.
In general, the waste of PC endurance board during construction can be controlled at 6%-8%. If this value is exceeded, it may be caused by not following the normal operation method. At this time, we must draw our attention and inform the construction staff to operate in accordance with the formal process, which can save a lot of costs.
In addition to using the endurance board in accordance with the regular process, in order to reduce waste, the cut endurance board can be used rationally. Under normal circumstances, it can be used as future repairs. At the same time, it can also be used for some damage to the endurance board on the building. It is convenient and economical to repair a small piece of endurance board at this time.
This will involve the preservation of the endurance board. It is very simple. Just be careful not to expose it to the sun and try not to remove the protective film on the surface of the board if you don’t use it; if there is dust on the board, you can scrub it with clean water, normal. It is fine to clean with water below 50 degrees, but remember to use neutral detergents, not acidic and alkaline detergents; and after cleaning, rinse with clean water, and then dry.